Started off on Wednesday with the school closure due to inclement weather, and had my eldest help me tear down my jointer table, and the old, heavy, unsteady planer stand on rickety old plastic rollers.
Then yesterday, after what felt like an ineffective interview with a potential new design client I built myself a 24″ deep, by 39″ wide, and 16.5″ high wheeled cart to house both my jointer and planer, so I can store them under my table saw. I was fortunate enough to be able to reuse some of the wood from the prior jointer stand to reinforce the new joint venture. Added a low shelf to put paddles and spare Allen keys on, and I’m good to go.
May find I want to bolt the items down, but I’m not sold on that yet. I used the better part of three two by fours, one two by six, a two by two foot piece of half inch ply wood, and a 39x24x.75″ piece of MDF for the top. Various 3″, 2″ and 1.5″ wood screws were used. I had a set of swiveling caster wheels already, two that lock, and two that do not. I have about 3/8ths of an inch gap before the top most part of my planer will hit the lowest part of the saw. I though a half inch would work, but I’m ok going just a bit tighter than that. Looks ugly but it works for me. Plus it got started and finished in about 2 or so hours. Lots of pre-drilled holes, and repeat cutting. Braced both top and bottom for the weight.
And today I build a six panel cubby for my drill, impact driver, staplers, 2 sizes of pin/Brad nailers and a heat gun. Works like a charm, and used up scraps left over from the jointer/planer cart. Win – win! That is 26″ wide, 13″ high, and about 11.5″ deep. So not huge, but not small either. I should have added a seventh cubby spot, but I was more concerned with not having to fight to pull items out of each cubby, so I got generous with my spacing. Could have been more conservative, but it works, is labeled, and everything fits as intended. Plus now I can get rid of a handful of plastic cases that I had to dig through everytime I wanted a tool. If you needed more than one you could be certain they would fall off a bench or get knocked over, and I’d have to go looking for oil bottles, Allen wrenches and any extra caps or guards that were stored in each case. Ugh. What a pain. But, no more! Out in the open, easy to reach from the bench. This also opened up some space on one of my other carts, so bully for me!
I was going to wait and use my new Dado stack to build the cubby for tools, but I didn’t feel like waiting for the new table saw cover to arrive, which will be in two weeks time. It would have been more professional looking, for sure. But it was to help me stay organized not be a showcase for any sort of wood working talent. That’s also why I used miss matched scraps that were three or four different colours. And some of it was particle board, mdf, and plywood. Not a glorious item to behold.
I would like to make a router bit holster in the near future, because I have several bits now, and they are all in boxes, bags, or cases and not easy to get to. If I can get them out in the open, and build my 12×12″ router base from clear acrylic I’ll be able to do more custom pockets and mortising. Which reminds me i need to build my router table at some point. I have the plate ready to go. Always more to do than expected. But once i get these things done, i have them at my finger tips for when i actually build something of consequence. The router sled for flattening is on my to-do list too.
If I refinish anything or start my hickory slab coffee table, I’ll be sure to take photos as I go, since that will require a fair few operations, jigs, and tools.
Greatwall Studios Graphic Design 